Equine Fusion All Terrain Stud Kit
Product Description
The Equine Fusion All Terrain Stud Kit comprises of 40 studs, slightly larger than those used for the Ultimate, and an installation tool which can be used in an electric drill.
The studs are easy to install and remove and give avery good grip on snow and ice and other slippery surfaces, without compromising the properties of the boots or joggin shoes. The studs can be installed when needed and removed when not.
There is no need to use the Equine Fusion dampening pads when using the studs in the All Terrain boot.
Stud Installation
Stud Installation
How to install studs in Equine Fusion boots:
1. To begin, you need the boots, a stud kit with tool and a power drill
2. Install tool in the drill
3. Insert one stud into the tool
4. Align the cutting edge of the stud with the centre point of the selected rubber tread
5. Press stud firmly into the boot while using the drill to rotate (start slowly) the stud into the boot.
6. Stop when the upper edge of the stud is flush with the rubber
7. Repeat until the recommended number of studs are installed in the boot.
Some extra pointers on how to make sure that the studs are securely fastened in the sole:
1. Use a 3 - 4 mm drill to make a hole before installing the studs.
2. Clean the studs with methylated spirits.
3. Fill the holes with Loctite or similar glue
4. Screw the studs in and let the glue dry.
5. Ready to use.
N.B. The drill can also be used to make the holes without needing to use the glue.

Equine Fusion All Terrain Stud Kit